pH和温度对2,2’,4,4’-四溴联苯醚在土壤中吸附和解吸行为的影响研究

研究了pH和温度对2,2’,4,4’-四溴联苯醚(BDE-47)在土壤中的吸附和解吸行为的影响。结果表明,pH和温度都可以影响BDE-47在受试土壤中的吸附和解吸行为。pH升高或降低均会使土壤对BDE-47的吸附能力提高,且在碱性环境中提高的程度更大;酸性或碱性条件下BDE-47在土壤中的解吸滞后性显著增强。温度降低后,土壤对BDE-47的吸附能力提高,5℃时的单点分配系数(Kd,表征土壤对BDE-47的吸附能力)是25℃时的1.03~1.67倍;温度由25℃降低到5℃后,BDE-47在土壤中的解吸滞后性增强。     

热处理时间对餐厨垃圾高温干式厌氧发酵的影响

餐厨垃圾中有机物大部分以大分子的形式存在,对其进行热处理,破坏大分子有机物的存在形式,将会影响其干式厌氧发酵的过程。实验对餐厨垃圾进行了热处理(100℃),处理后将其在含固率(TS)20%、接种率25%的条件下进行高温55℃厌氧发酵。实验结果表明,热处理后,餐厨垃圾的理化性质发生显著变化,累计产气量、TS和VS的去除率均增大。当热处理时间为15 min时,餐厨垃圾的SCOD值最高,为59.49 g/L,比未处理时提高了3.3倍。同样该条件下,累计产气量也最高,为2 782.8 m L,与未处理相比累积产气量提高58.30%,第二产气高峰比未处理提前3天。各发酵瓶发酵前后TS、VS去除率的变化趋势与累计产气量的变化基本一致,累计产气量越大,TS、VS的去除率越大。     

粉末活性污泥处理含铀废水的特性

以生活污水处理厂剩余活性污泥为原料,制备粉末活性污泥(PAS)作为生物吸附剂,考察p H值,PAS投加量,U(Ⅵ)初始浓度和吸附时间对PAS吸附U(Ⅵ)的影响,探讨了PAS吸附U(Ⅵ)的作用机理。实验结果表明,在U(Ⅵ)初始浓度为10 mg/L时,其最佳吸附p H值为3,去除率97.77%,吸附平衡时间120 min;吸附过程较好地拟合了准二级动力学模型(R2≈1)和Freundlich等温模型(R2≈1);X射线能谱和离子交换实验分析表明,离子交换为其主要吸附方式,参与交换的主要离子为Ca2+;红外光谱分析表明,PAS吸附U(Ⅵ)后自身结构未发生改变。以0.1 mol/L的HCl溶液作为解吸液,初次解吸率达92.83%,循环利用3次仍具有较好的吸附效果。     

单光子/光电子在线质谱实时分析聚氯乙烯热分解/燃烧产物

实验室研制了低能光电子磁场增强电离(MEPEI)和单光子电离(SPI)复合电离源,该电离源具有电离化合物范围宽、碎片离子少、质谱图简单等优点,结合飞行时间质谱(TOF-MS)实现了聚氯乙烯(PVC)热分解/燃烧产物的在线分析.针对不同的目标化合物,MEPEI/SPI复合电离源通过调节电离区电场强度,可以快速在SPI和SPI-MEPEI之间切换.PVC热分解/燃烧产物中电离能大于光子能量(10.60 eV)的HCl和CO2(12.74 eV、13.77 eV)利用MEPEI模式电离;而烯烃、二氯乙烯、苯系物、氯苯、苯乙烯、茚满及萘系物等可通过SPI-MEPEI复合模式电离.通过实时监测PVC主要燃烧产物的信号强度随温度的变化趋势可推断出,PVC燃烧产物主要是通过两种机制生成:①250～370℃时,PVC发生脱氯及分子内环化反应,产生大量的HCl、苯和萘;②380～510℃时,PVC发生分子间交联反应,生成烷基芳烃,如甲苯和二甲苯/乙苯等.实验结果表明,SPI/SPI-MEPEI复合离子源TOF-MS分析速度快,应用范围广,在在线分析中具有广泛的应用前景.     

Utilizing surfactants to control the sorption, desorption, and biodegradation of phenanthrene in soil-water system

An integrative technology including the surfactant enhanced sorption and subsequentdesorption and biodegradation of phenanthrene in the soil-water system was introduced and tested. For slightly contaminated agricultural soils, cationic-nonionic mixed surfactant- enhanced sorption of organic contaminants onto soils could reduce their transfer to plants, therefore safe-guarding agricultural production. After planting, residual surfactants combined with added nonionic surfactant could also promote thedesorption and biodegradation of residual phenanthrene, thus providing a cost-effective pollution remediation technology.0ur results showed that the cationic-nonionic mixed surfactantsdodecylpyridinium bromide (DDPB) and Triton X-100 (TX100) significantly enhanced soil retention of phenanthrene. The maximum sorption coefficient Kd* of phenanthrene for contaminated soils treated by mixed surfactants was about24.5 times that of soils without surfactant (Kd ) and higher than the combined effects of DDPB and TX100 individually, which was about 16.7 and 1.5 times Kd , respectively.0n the other hand, TX100 could effectively remove phenanthrene from contaminated soils treated by mixed surfactants, improving the bioavailability of organic pollutants. Thedesorption rates of phenanthrene from these treated soils were greater than 85% with TX100 concentration above2000 mg/L and approached 100% with increasing TX100 concentration. The biodegradation rates of phenanthrene in the presence of surfactants reached over 95% in30days. The mixed surfactants promoted the biodegradation of phenanthrene to some extent in 10-22days, and had no obvious impact on phenanthrene biodegradation at the end of the experiment. Results obtained from this study provide some insight for the production of safe agricultural products and a remediation scheme for soils slightly contaminated with organic pollutants.     

Preparation of MgO/B2O3 coatings by plasma spraying on SUS304 surface and effects of heat-resistant

This study mainly deals with the preparation of MgO/B₂O₃ coatings by plasma spraying on the SUS304 surface and the effects of heatresistant. The power materials of low thermal conductivity were selected to control the heat divergent performance of high temperature parts. The reticular micro-structure between the cover thermal layer and the substrate was prepared by using the plasma spraying method. The powder mixture of MgO and B₂O₃ were selected as spraying materials and the SUS304 was used as the substrate material. The MgO/B₂O₃ coating was prepared on the surface of the SUS304 to provide better cover thermal performance. The properties of the microstructures and the morphologies were studied by Optical Microscope, Scanning Electron Microscope, Electron Probe Microanalyzer, and X-ray Diffraction. The results showed that the cover thermal performance has been improved.     

热脱附-气相色谱-质谱法测定环境空气中5种挥发性卤代烃

建立热脱附-气相色谱-质谱联用测定环境空气中三氯甲烷、四氯化碳、三氯乙烯、四氯乙烯、溴仿等5种挥发性卤代烃的分析方法。该方法在一定浓度范围内工作曲线线性良好,相关系数均在0．9990～0．9998之间,加标回收率在94．0％～106．6％之间,RSD为2．18％-7．62％,检出限为0．22μg／m3～0．30μg／m3。该方法具有操作简单、分析快速、准确度高、灵敏高的特点,用热脱附-气相色谱-质谱联用测定环境空气中5种挥发性卤代烃,结果令人满意。     

自然型氨基酸及其钾盐的 CO2吸收和再生特性

在CO2吸收过程中,选择具有不挥发和不发生氧化降解特性的氨基酸盐吸收剂有助于降低吸收剂损失和减轻环境污染风险,故本研究以CO2吸收速率和再生速率为指标,对L-精氨酸和精氨酸钾（PA）吸收剂的CO2吸收性能和常压下热再生性能进行了实验分析,并研究了吸收剂质量分数、反应温度及吸收-再生循环次数对CO2吸收特性的影响,同时还与乙醇胺（MEA）、二乙醇胺（DEA）和三乙醇胺（TEA）进行了对比分析.结果表明,在实验的质量分数范围内,PA具有最高的CO2吸收速率和吸收能力,分别为24.5×10-3mol.（L.min）-1和1.99 mol.mol-1,比相同质量分数的MEA高2.1%和290.2%.温度影响结果表明,40℃时PA和MEA的CO2吸收速率均高于其他实验温度.相同再生条件下,PA的贫液CO2负荷要略高于MEA,但PA的再生程度可达72.8%,比MEA高19%.同时,3次＂吸收-再生＂循环之后,10%PA的CO2吸收能力仍可保持在1.03mol.mol-1,比10%MEA高255.2%.实验结果也表明,L-精氨酸具有较强的CO2吸收能力,其CO2吸收速率与同质量分数的DEA可比.     

关于医疗垃圾飞灰中二噁英在惰性气氛下的低温热脱附研究

以医疗垃圾焚烧炉布袋除尘器前管道内飞灰(BG)及布袋除尘器后飞灰(AG)为对象,研究不同温度及时间段下其在管式炉中的热脱附特性.结果表明,在低温氮气气氛下,热脱附作用较为明显,2种飞灰中的二噁英都有了不同程度的脱除,其中布袋前飞灰中二噁英的脱除率为82.9%～99.9%之间,毒性当量脱除率为77.3%～99.8%,布袋后飞灰中二噁英的脱除率为66.8%～99.8%之间,毒性当量脱除率为43.5%～99.6%.检测收集到的实验尾气,发现了二噁英的存在,且在300～350℃这个温度段生成量最多,且生成的有毒二噁英同系物中以OCDD为主.通过比较发现,当温度为400℃,加热时间为45 min时2种飞灰中的二噁英脱除效率最高.鉴于惰性气氛下的热脱附对处理飞灰中的二噁英具有较好的作用,可将其大规模应用于实际工程中.     

热脱附-气相色谱法测定空气中的总挥发性有机化合物研究

建立了热脱附-毛细管气相色谱法测定空气中苯、甲苯、乙酸丁酯、乙苯、对/间二甲苯、邻二甲苯、苯乙烯和十一烷等挥发性有机物的检测方法。九种挥发性有机物在一定浓度范围内标准曲线线性良好,相关系数均在0.997~0.999之间。检出限在0.002~0.005 mg/m3(采样体积1.0 L计)。用该方法检测了企业产生的有机废气及厂区周边环境空气,实验结果表明该方法灵敏度高、操作简单、重现性好、准确可靠,能够满足对实际样品的分析要求。